1. Remove wing
from screw. Insert screw in hole of bracket or clamp to be
anchored.
2. With wing
replaced on screw, force wing through hole drilled in wall. Wings
can be compressed with fingers; or simply pushed through hole and
will compress themselves.
3.
Wings have now
snapped back into
position, screw is
tightened, and bracket
is held securely against wall.
NO. 1 TUMBLE TOGGLE
1. Turn wing to position
parallel to bolt and insert through hole drilled in wall.
2. Wing flips to
vertical by gravity. Remove nut and place bracket over bolt.
3. Replace and tighten nut.
Bracket is now held in place.
